Tibo Plus 1.1, Руководство пользователя

Страница: 9 / 16

Plus 1.1 / 2.1 / 3.1 User Manual
Page
8 / 15
2.4. Setting up your speakers
The powered speaker system is designed for either bookshelf or stands mounting.
The stands should be of rigid construction, between 45 cm to 69 cm high and
preferably have spikes.
The space between the two speakers and the distance from the listener is important.
If the speakers are positioned too close or too far apart, stereo imaging will not be
fully developed. Speakers are designed to perform optimally positioned at least 20
cm from the rear wall in an average listening room. However, it may not be possible
to install the speakers in this position and since rooms vary in shape, size, and
furnishing, a certain amount of experimentation is necessary to determine the most
suitable position.
Moving the speakers very close to the rear wall will enhance the bass frequencies
but will tend to reduce soundstage depth, while moving the speakers away from the
rear wall will tend to have the opposite effect. Avoid positioning the speakers close to
or in the corners of the room, as this will excite undesirable room coupling in the low
and middle frequencies.
If the width of the rear wall is limited, then toe-in the speakers slightly to reduce
reflections. Room characteristics and positioning have a profound effect on the
performance of the speakers, so time and effort devoted to achieving the optimum
positions will be rewarded.
Ensure that the ON/OFF Switch is in the OFF position. Connect the two speakers
together as shown below using the supplied speaker cable. Connect the RED (+)
and BLACK (−) terminals from the active speaker (left channel) to the corresponding
terminals on the passive speaker (right channel).