THORLABS TSP-TH, Руководство по эксплуатации

Страница: 21 / 39

© 2018 Thorlabs
4 Write Your Own Application
19
4 Write Your Own Application
Please refer to the correct chapter, depending on the Version of TSP01 you are using.
4.1 WYOA for TSP01 RevB Sensors
This section provides information on writing your own application for TSP01 sensors labeled
RevB. Previous-revision TSP01 sensors require the installation of NI-VISA™ and the use of dif-
ferent drivers. For more information on previous-revision sensors, please refer to section 4.2:
"
Write Your Own Application for Previous-Revision Sensors ".
In order to write your own application, you need a specific instrument driver and some tools for
use in different programming environments. The driver and tools are installed to your computer
during software installation.
Note
TSP01 software and drivers are 32 bit applications. As for this reason, in 32 bit systems, they
are installed to
“C:\Program Files”
while in 64 bit systems - to
“C:\Program Files (x86)”
In the table below you will find a summary of the files needed for specific programming environ-
ments. Section 4.2 specifies the locations of these files.
Programming environment Necessary files
C, C++, CVI
*.h (header file)
*.lib (static library)
C#
.net wrapper dll
Visual Studio *.h (header file)
*.lib (static library)
or
.net wrapper dll
LabView
™
*.fp (function panel)
Beside that, LabVIEW
™
driver vi's are provided with the
*.llb container file
In the next section the location of above files for all hardware, supported by TSP01 RevB
drivers, is described in detail.
4.1.1 Driver Installation and Location for TSP01 RevB Sensors
This section describes the driver installation for TSP01 RevB sensors.
Note
For instructions on the driver installation for previous-revision TSP01 sensors, please refer to
the instruction in the chapter "
Write Your Own Application for Previous-Revision Sensors ".
22
22