4
HA0200T Rev 11 Jun 2022
Chapter 3
3.3 Installing the Breadboard
3.3.1 Rigid Mounts
The breadboard rests on rubber pads, three in each corner of the frame. Levelling of the work surface is acheived by adjusting
the feet.
A Installation
1) Ensure the frame is correctly sited and level – see Section 3.1.
2) Fit the lifting handles supplied to the breadboard as shown.
3) Observing the warnings listed above, lift the breadboard into position.
4) Use a suitable levelling device to check the breadboard is level. Repeat Section 3.1. as necessary.
5) Tighten the locknuts on the feet.
6) Populate the breadboard.
Fig. 3.3 Fitting the breadboard
B Removal
To remove the breadboard, reverse the installation procedure.
Note
The desk is normally supplied with the anti-vibration mounts and breadboard already fitted. Item (2) is applicable only if the
unit has been shipped or air-freighted to its destination
Warning
During item (2):
When lifting breadboards, use the lifting handles supplied.
Safe lifting precautions must be observed. In particular, do not lift more than 25 kg (55 lb) per person.
Use more people as necessary.
Breadboards should be lifted only in an unpopulated condition.
Caution
During item (6), the total load including the breadboard must not exceed 700kg (1545 lb).
Warning
During item (2):
When lifting breadboards, use the lifting handles supplied.
Safe lifting precautions must be observed. In particular, do not lift more than 25 kg (55 lb) per person.
Use more people as necessary.
Breadboards should be lifted only in an unpopulated condition.
