THORLABS LFE1220W-EU, Руководство по установке

Страница: 4 / 68

LFE1220W-US, -EU, and -UK Laminar Flow Enclosures Chapter 2: Safety
Page 2 ETN056370-D02
Chapter 2 Safety
For the continuing safety of the operators of this equipment, and the protection of the equipment itself, the operator should
take note of the Warnings, Cautions and Notes throughout this handbook and, where visible, on the product itself.
Warning: Risk of Electrical Shock
Given when there is a risk of electrical shock.
Warning
Given when there is a risk of injury to the user.
Warning: Risk of Finger Trap
Given when there is a risk of trapping fingers between parts.
Caution
Given when there is a possibility of damage to the product.
Note
Clarification of an instruction or additional information.
2.1. General Warnings and Cautions
Warning: Risk of Electric Shock
The Filter Unit is powered by mains voltages. This is hazardous and can cause serious injury. Appropriate care
should be taken when using this device.
Cables for wiring the Filter Unit are not supplied. These must be provided by the person responsible for
installation and must conform to any applicable local standards.
The unit must be installed only by suitably trained and qualified personnel who understand the hazards
associated with using high voltages and the steps necessary to minimize the risk of electrical shock.
Warning:
If this equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment
may be impaired. In particular, excessive moisture may impair operation.
The equipment is for indoor use only. The equipment is not designed for use in an explosive atmosphere.
Where a Warning symbol appears on the product (e.g. finger trap warning), users must consult this manual to
ascertain the nature of the potential hazard and the means of avoiding them.
Warning: Frame Loading
The construction-rail design of the LFE is intended to allow customers to easily attach and build onto the basic
frame. In this case, the total load in addition to the parts supplied in the kit must not exceed 300kg, with no
more than 100 kg applied to any single construction rail.
To prevent the frame toppling, any attached load which acts outside the perimeter of the frame should not
create a moment load >1600Nm about an axis between any 2 of the feet.
Do not put heavy objects on the roof panels.