Microscope and Tablet Mount Kit
Chapter 2: Setup
Rev A, November 2, 2018
Page 3
6. Remove the two screws at the top of
the mast using the 3/32" hex key.
7. Place the tablet on the mast's cradle.
To allow the tablet to fit in the cradle, it
may be necessary to loosen the two
screws holding the cradle in place.
8. Place the top clamp over the top of the
tablet as shown.
9. Replace the two screws removed from
the top of the mast and capture the top
clamp. Tighten the two screws until the
tablet is secure.
10. Pick up the second (longer) USB cable,
and plug the micro B end into the power
port of the tablet.
11. Plug the other end of the cable into the
USB port at the top left corner of the
cleaver.
