THORLABS ITC8 Series, Руководство по эксплуатации

Страница: 51 / 84

Commands 45
_________________________________________________________________________________
_____________________________________________________________________________________________________
© 2010 Thorlabs
3.2.4 Thermistor calibration (Steinhart-Hart method)
Programming:
":CALTC1:SET <NR3>"
Set the Steinhart-Hart coefficient C1
":CALTC2:SET <NR3>" Set the Steinhart-Hart coefficient C2
":CALTC3:SET <NR3>"
Set the Steinhart-Hart coefficient C3
Reading:
":CALTC1:SET?"
Reads the Steinhart-Hart coefficient C1
[:CALTC1:SET <NR3><LF>]
":CALTC2:SET?"
Reads the Steinhart-Hart coefficient C2
[:CALTC2:SET <NR3><LF>]
":CALTC3:SET?"
Reads the Steinhart-Hart coefficient C3
[:CALTC3:SET <NR3><LF>]
":CALTC1:MIN?" Reads the minimum C1 allowed
[:CALTC1:MIN <NR3><LF>]
":CALTC2:MIN?" Reads the minimum C2 allowed
[:CALTC2:MIN <NR3><LF>]
":CALTC3:MIN?" Reads the minimum C3 allowed
[:CALTC3:MIN <NR3><LF>]
":CALTC1:MAX?" Reads the maximum C1 allowed
[:CALTC1:MAX <NR3><LF>]
":CALTC2:MAX?" Reads the maximum C2 allowed
[:CALTC2:MAX <NR3><LF>]
":CALTC3:MAX?" Reads the maximum C3 allowed
[:CALTC3:MAX <NR3><LF>]
(Refer to chapter 2.2.8.3, "Steinhart-Hart method" on page 35)
For selection between both methods, see the note on the previous page!