THORLABS ELL6, Руководство по эксплуатации

Страница: 16 / 21

ELL6K Dual Position Optics Slider Kit Chapter 5: Troubleshooting and FAQ
Page 14 DTN000414-D02
5.2. Notes on Making a Picoflex Cable for Use when Daisy Chain Devices
The multi-drop communications bus offers the option of connecting the slider to a hybrid network of up to 16 Elliptec
resonant motor products and controlling the connected units with a device such as a microprocessor. When multiple
units are connected to the same interface board, all can be controlled simultaneously using either the software or
the buttons on the interface board.
When making a cable to operate multiple devices it is important to observe the correcr pin orientation. The following
procedure offers guidance in making such a cable.
1. Gather together the parts required.
a) Ribbon cable 3M 3365/08-100 (Farnell 2064465xxxxx.
b) Female crimped connectors as required - model number MOLEX 90327-0308 (Farnell order code
673160) (Qty 1 female connector above is shipped with each stage unit).
c) Suitable screwdriver and scissors or other cutting tool.
2. Orientate the first connector correctly to mate with the connector on the stage, then arrange the ribbon
cable as shown with the red wire aligned with pin 1 (identified on the pcb by a small triangle). Slide the
connector onto the ribbon cable as shown.