THORLABS CAL110, Руководство пользователя

Страница: 11 / 68

SD-OCT Base Unit Chapter 2: Setup
Rev E, November 7, 2018 Page 7
Chapter 2 Setup
2.1. Unpacking
Carefully unpack the components from the transport boxes. Make sure that all components are delivered
according to the packing list included in the transport box. After unpacking, store the packing cartons and inserts.
You may need them in case of a service or upgrade of your OCT system.
2.2. System Connections
Base Unit Connections
All OCT base unit connections are located in the rear (see Figure 5).
Figure 5 Rear View of OCT Base Unit
A.
Power Plug
B.
USB Data Port to Connect PC (USB 2.0 Type B Interface)
C.
Fiber Connection to the Imaging Scanner (FC/APC)
o
In Telesto-PS Series base units a fiber cable is permanently installed
D.
Auxiliary Fiber Connection to Imaging Scanner (FC/APC) – Not in Telesto Series and some
Ganymede Series base units
E.
Probe Connection Port (LEMO, 19 Pin)
F.
Auxiliary Connection Port (LEMO, 14 Pin)
G.
CameraLink Connection:
o
Med/Full – Only in some Ganymede and some Telesto Series Base Units
o
Camera 0 – Only in Telesto-PS Series base units (not shown above)
H.
CameraLink Connection
o
Base – Not in Callisto Series base units
o
Camera 1 - Only in Telesto-PS Series base units (not shown above)
I.
Trigger Connection SMB – Not in Callisto Series base units
Internal Electrical Connections
The USB connection to the PC is used for the control communication between the Software and base unit.
The acquisition and synchronization of the spectral information is using the CameraLink and the Trigger
connection.