INSTRUCTIONS OF USE
FILL THE WATER TANK
NOTE: Do not remove or cut the small rubber valve on the top of the
water tank cap (FIGURE 9-A). Do not turn the unit over when the water
tank is full - water may escape through the valve.
1. Make sure the steam control dial is in the “OFF” position.
2. Twist the water tank cap a quarter of a turn in the "Unlock" direction
(counterclockwise) indicated by the marking on the cap, then
remove it.
3. Carefully fill the cup to the maximum with water and pour the
contents through the filling hole. Repeat the operation up to two
times to fill the water tank to the maximum (the tank can hold 380
ml of water).
4. NOTE: To minimize lime build-up and extend the life of your
multifunction steam mop, we strongly recommend that you use
distilled or deionized water.
5. Replace the water tank cap. Press the cap on the water tank and
make sure it is securely closed. Turn the plug a quarter turn
clockwise (as indicated by the "Lock" mark) to lock it.
NOTE: The tube transferring water from the water tank to the boiler has
a copper ball that acts as a weight. This is intended specifically to
improve the efficiency of water use. It is therefore normal to hear a
clicking sound from the water tank during use.
If you suspect the copper ball has dislodged from the tube, see the
Troubleshooting Guide for the solution and reconnect it.
EN-15
