THOMSON SpeedTouch 580, Инструкция по установке и настройке

Страница: 28 / 50

Chapter 2
Basic Installation
22
E-DOC-CTC-20050429-0061 v2.0
2.5 Connections Overview and Powering
Introduction
In case you want to make the required connections yourself without using the
guided installation procedure as recommended, you must:
Make sure to read the safety instructions and regulatory notices first.
Follow the order as indicated below for making connections to your
SpeedTouch™.
DSL Connection
Use the grey DSL cable to wire the SpeedTouch™ DSL port to your telephone wall
outlet or distributed filter.
Powering the
SpeedTouch™
Plug in the coaxial jack from the electric power supply adapter into the
SpeedTouch™ power inlet port and the other end to the wall outlet.
To power on the SpeedTouch™, press the power button on the SpeedTouch™ rear
panel.
During the start-up procedure, the power LED on the front panel is lit red for some
seconds. As soon as the power LED is solidly lit green, your SpeedTouch™ is ready
for service. After another couple of seconds, also the DSL LED will light green.
If these LEDs do not light, please refer to ”Checking the LEDs” on page 33 . A
comprehensive LED overview can be found in the SpeedTouch™ User’s Guide.
To power off your SpeedTouch™, use the same button.
Network connections
Your SpeedTouch™ allows you to connect your computer(s) via:
Ethernet
USB
Wireless networking
The safety instructions can be found on the Setup CD (see “2.2 First
Time Installation” on page 7 ) and/or may also be provided as printed
booklet.
!
The SpeedTouch™ electrical power requirements are indicated on the label
on the bottom side of your SpeedTouch™. In case you need to use another
power supply than the one provided, make sure that the spare supply
complies with the SpeedTouch™ power requirements.
It is recommended to use the Guided Installation procedure.
See “2.2.1 Guided Installation” on page 8 for more information.