THOMSON Grass Valley KAM-HD-MULTI, Инструкция по эксплуатации

Страница: 93 / 102

KAM-HD-MULTI—Instruction Manual 93
Kameleon HD Links and Web Pages
Locate Module
Selecting
Flash
from the
Locate Module
pulldown flashes the yellow COMM
and CONF LEDs on the front of the module so it can be located in the
frame.
Slot Identification
You may identify the module by typing a specific name in the
Name
field.
The assigned name is stored on the 2000NET module and travels with the
2000NET module if it is moved to another frame. Select
Default
to enter the
factory default module name.
An asset identification may be entered in the
Asset Tag
field. This will appear
on the module Status web page and in the NetConfig inventory report.
Slot Memory
The slot configuration for each media module is automatically saved peri-
odically (once an hour) to the 2000NET module in that frame. You may also
select the
Learn Module Config
button at any time to save the current configu-
ration for this slot. The configuration is saved on the 2000NET module. If
the 2000NET module is removed or powered down, the stored configura-
tions are not saved.
When the
Restore upon Install
box has been checked, the current configuration
saved to this slot is saved as slot memory. When the current module is
removed and another module of the same type and software version is
installed, the configuration saved to the 2000NET module will be down-
loaded to the new module. The box must be checked before the current
module with the saved configuration is removed.
If a different type of module is installed in this slot, a warning message will
state that the original module type has been replaced with another module
type. In this case, a
Clear
button will appear allowing you to clear the stored
configuration from the previous module.
Note Uncheck the Restore Upon Install button before downloading new software.
Frame Health Reports Link
Select the Frame Health Reports link to open the 2000NET module Frame
Alarm Reporting web page. This web page allows configuration of the
alarms and warnings that are reported to the external Frame Health Alarm
connector on the rear of the 2000T3 frame (not present on the 2000T1
frame).