THOMSON Grass Valley KAM-HD-MULTI, Инструкция по эксплуатации

Страница: 23 / 102

KAM-HD-MULTI—Instruction Manual 23
Configuration and Adjustments
Audio Preset Configurations
There are four different audio preset configurations. Selection of one of
these configurations is done with the Audio Preset Config buttons on the
E-MEM web page (
E-MEM Web Page on page 85 ). Each of these configura-
tions is intended to preset the audio inputs and outputs and set audio
parameters for a specific audio application.
Note Audio presets are designed to act as a starting point only. You will need to go
through each setup to make sure the parameters meet the needs of your
application.
The following Audio Preset Configs can be selected:
DeEmbed
Selecting
DeEmbed
configures the module for no AES audio inputs and eight
audio outputs. It is primarily for applications where demultiplexing
embedded audio is required to be output to the external AES audio connec-
tors.
Embed
Selecting
Embed
configures the module for eight AES audio inputs and no
AES audio outputs. This application can be used for applications where
external audio is fed to the module and embedded into the output video
stream.
Universal 8 Ch
Selecting
Universal 8 Ch
configures the module for four AES audio inputs and
four AES outputs. The Demuxed audio Groups 1-2 are sent to the four
external AES outputs. External AES audio inputs 1-4 are multiplexed into
Groups 1 and 2 of the output video stream.
Transcode
Selecting
Transcode
, configures the module for no AES audio inputs and
eight audio outputs. All eight demuxed audio streams are delayed and
bypassed then selected for insertion into the output audio stream (multi-
plexed) and to the eight AES connectors on the rear module.
Refer to Table 3 on page 24 for a complete summary of the settings for each
Audio Preset Configuration.