thomann Stairville All FX Bar, Руководство пользователя

Страница: 19 / 40

7.4 Operating mode DMX
This setting is only relevant if the device is controlled via a DMX controller.
1.
Press [MENU] repeatedly, until the display shows ‘dMX’ and confirm with
[ENTER] .
ð
The display shows ‘d 1’ .
2.
Press [ENTER] again to open the settings menu for the DMX mode.
3. Press [UP] or [DOWN] to select the desired DMX mode and confirm with
[ENTER] .
The following DMX modes are available:
Menu level 2 Description
‘02Ch’ 2-channel mode
‘05Ch’ 5-channel mode
‘08Ch’ 8-channel mode
‘10Ch’ 10-channel mode
5.
After confirming the DMX mode, press [UP] or [DOWN] to select a value
between 1 and 512 for the desired DMX address (display shows ‘d 1’ … ‘d512’ )
and confirm the selection with [ENTER] .
Make sure that this number matches the configuration of your DMX controller.
The following table shows the respective highest possible DMX address for the
various DMX modes.
Mode Highest possible DMX address
2-channel mode 511
5-channel mode 508
8-channel mode 505
10-channel mode 503
6.
To return to the main menu without making changes, press [MENU] .
7.5 Operating mode Slave
In this mode, the device exactly follows the operation of the master that it is con‐
nected to.
1.
Press [MENU] repeatedly, until the display shows ‘SLA’ and confirm with
[ENTER] .
ð
The display shows ‘SLAV’ . The Slave mode is activated.
2.
To return to the main menu without making changes, press [MENU] .
Setting the DMX mode
Setting the DMX address
Operating
All FX Bar
19