thomann MIX 1202, Руководство пользователя

Страница: 9 / 16

9
MAIN OUT
2$
These 1/4“ TRS jacks represent the end of the mixer chain, where your fully mixed stereo signal enters
the real world. Connect these outputs to the inputs of your amplifiers, powered speakers, or serial effects
processor (graphic equalizer, for example).
CTRL ROOM OUT
2%
These 1/4“ TRS are used to assign the control room signal to the studio monitor speakers. They can also be
used to provide another main mix output, or to monitor the CD/TAPE Inputs (when engage the TAPE TO CTRL
RM/PHONES switch), or to monitor the aux send signal (MIX 1202 only with FX TO CTRL ROOM switch is
engaged)
AUX SEND OUT
2^
These 1/4“ TRS are used to send out the signal from the AUX bus to external device such as effects
equipment. Each channel has an AUX SEND control knob that adjusts how much of that channel‘s signal
appear at each of the output. This output is affected by the channel LEVEL, but not MAIN MIX control.
PHONES OUTPUT
2&
This jack is used to send out the mix signal to a pair of headphones, and the signal is the same as the CTRL
RM OUTS outputs. The level is controlled by the CTRL ROOM/PHONES knob. You can listen to the Main Mix,
the CD/TAPE, or the AUX SEND (MIX 1202) depending upon the position of the TAPE TO CTRL RM/PHONES
switch and FX TO CTRL ROOM switch.
Rear Panel
POWER IN
2*
This connection is where you connect the supplied external AC power supply to provide AC power to the mixer.
Connect the external power supply to your mixer first, then plug the power supply into a suitable and properly
rated AC outlet.
NOTE: Make sure you use the correct external power supply cable of providing 18.5 VACx2 at 150
milliamperes.