thomann MIX 1202, Руководство пользователя

Страница: 6 / 16

6
HIGH
r
This is the treble control. You can use it to get rid of high frequency of the human voice. The gain range goes
from -15 dB to +15 dB with a centre frequency of 12 kHz.
MID EQ (except MIX 502)
t
This control provides 15 dB boost or cut at 2.5 kHz. It can affect most fundamental frequencies of all musical
instruments and human voice.
LOW EQ
y
This is the bass control. It is used to boost male voice, kick-drum or bass guitar. Your system will sound much
bigger than what it is. The gain range goes from -15 dB to +15 dB and the center frequency is 80 Hz.
75 Hz Low-Cut Switch (MIX 1202 only)
u
By pressing this button you will activate a 75Hz low frequency filter that cuts the bass frequency below 75Hz.
You can use this switch to reduce the hum noise caused by the mains power supply, or the stage rumble while
using a microphone.
+4/-10 Switch (MX 1202 only)
i
These switches are used to select the input sensitivity of the line inputs on the stereo channels. +4 dBu is
suitable for professional audio devices and -10 dBV is suitable for general devices. If not sure to use which
setting, try +4 dBu first, then change it to -10 dBV if the volume is too small to be satisfied.
AUX Send (except MIX 502)
o
This control is used to feed the mono input of parallel effects devices or the input of a stage monitor amplifier
via the AUX SEND output jack. All the channel controls (except PAN / BAL) will affect the AUX signal. The
signal is tapped off after the LEVEL control. The output from an external processor can come back via the
STEREO AUX RETURN inputs (on the MIX 802) or stereo channel (MIX 1202), and be added to the main mix.