THM Carbones Clavicula SE, Инструкция, Страница: 22 / 40

LOREM
T H M C L A V I C U L A S E 22
INSTALL
Chainring install
The Clavicula SE is designed for 2 chainrings. But of course you can install a 1x chainring. Please
note for this purpose we offer special washers to distribute the load evenly on the carbon
structure.
Danger of damage to the chainring mount .
-
The number of chainwheel teeth must never be less than the minimum number
required
–
see page 11.
-
Always observe the tightening torques specified by the manufacturer of the
chain ring bolts; however, do not exceed a max. tightening torque of
6 N·m
(53 lbf·in) under any circumstances.
Install 2 chainrings
-
Place the small
chainring with the
chainring nuts
(1) on
the inside
-
Apply grease to the
screws
(2)
- Place the big chainring
on the outside and
tighten the chainring
screws
(2) to 6 Nm
Install 1 chainring
- Place the
washer
(3) on
the chainring
nut
(1) :
- Place both on the
crank and place the
chainring on the
outside.
- Apply grease on the
screws
(3) .
-
Tighten the screws
(3) to 6 Nm
WARNING
1
1
3
2
2