THINKWORK PW120, Руководство пользователя

Страница: 6 / 28

● Polishing bonnet (f~g) can be hand washed in warm water and mild detergent. It can be machine.
● Always start and stop the polisher on or against the surface.
Step 3:Place the cord over your shoulder and do flat surfaces first - hood, trunk and roof. Cover areas
quickly with broad, sweeping strokes in a criss-cross pattern (Fig-5).
● DO NOT press down on the polisher. The machine’s action, not pressure, does the best job.
Step 4
● After flat surfaces are covered with wax, do sides of the car. Hold the polisher as in (Fig-6). Let the
cord hang free. It is not necessary to use a criss-cross motion on doors and fenders.
Step 5
● Remove the foam applicator bonnet (f~g) and use it to hand polish all hard to reach surfaces, under
the bumpers, around the door handles, etc. as shown in (Fig-7).
Step 6
● Change the foam applicator bonnet (h~i) and put a clean polishing bonnet (f~g) on the polisher as
described in the section “Fitting the Foam Applicator or Polishing Bonnet (Fig-2) above.
Step 7
● Polish the wax in the same order it was applied. Use long, sweeping strokes in a crisscross pattern.
Do not press hard. Let the polisher do the work(Fig-8).
Handy Hints
● This waxer/polisher is a random orbit polisher. it is designed to wobble. The wobbling motion
produces the fine, swirl free finish.
● For best results, use light pressure only, letting the polisher do the work.
● Exercise caution around edges, corners or small surface areas. Prolonged polishing on edges
andcorners can damage these areas dried at the lowest setting however air drying is recommended.
● DO NOT USE ABRASIVE COMPOUNDS. Liquid wax is recommended to use with this polisher.
● The most common error is applying too much wax. If pad becomes saturated, it will not last as long
and polishing will be more difficult and take longer.
Too much wax may have been applied if:
● foam applicator bonnet continually comes off pad;
● buffing seems difficult.
● The polishing bonnet is only to be used for the final buff. Do not use it to apply wax.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
To prolong pad life and shape, always store polisher with pad face up.
Remove bonnet from pad when polisher is not in use so that pad can dry out and retain its original
shape.
Contact US
Should you have any questions about the item,or any thinkwork tool ever fails to give complete
satisfaction,save time and contact us for replacement,and our email is:
support@thinkworktools.com
We are open Monday through Friday from 8:00 a.m. to 5:30 p.m. Eastern Standard-Time.
04