www.mythinkcar.com
THINKTOOL Pros+/Pros
5
1.4 Charging
Follow the steps below to charge the main unit:
Connect one end of the power cord to the USB socket of the power adapter.
Connect the other end to the charging jack on the bottom of the main unit.
Plug the charger power plug into a power outlet to start charging.
When the battery status icon displays , the main unit has been charged.
When it displays , the charging process has been completed and you shall disconnect the main unit.
1.5 Battery
It is normal that the main unit won’t turn on when charging because the battery has not been used for a
long time or it is exhausted. Please turn on the main unit again after charging the battery for a while.
Please charge the main unit through the charger in the package. The company assumes no
UHVSRQVLELOLW\IRUGDPDJHVDQGORVVHVFDXVHGE\FKDUJLQJZLWKFKDUJHUVRWKHUWKDQWKRVHVSHFL¿HGE\
the company.
The battery can be recharged repeatedly. However, as the battery is wearable, the standby time of the
device will be shortened after long-time use. Please avoid frequent repeated charging so as to extend
battery life.
The battery charging time varies with temperature and battery status.
When the battery power is low, the system will pop up a prompt reminding you to connect the charger.
:KHQWKHEDWWHU\SRZHULVWRRORZWKHGHYLFHZLOOWXUQRႇ
1.6 VCI Connections
Connection steps as below:
(1) Locate vehicle’s DLC socket. Most of the DLC are standard OBD II diagnostic sockets (non-standard
OBD II vehicle diagnostic sockets need to use the corresponding adapter).The DLC is usually located
12 inches from the center of the instrument panel (dash), under or around the driver’s side for most
vehicles. If the DLC cannot be found, refer to the vehicle’s service manual for the location.
(2) For OBDII vehicle, follow the steps mentioned below to proceed:
a) Plug the VCI device into the vehicle’s DLC socket
b) Use the OBD II extension cable to connect the VCI device and DLC socket.
)RUQRQ2%',,YHKLFOH,IWKHSLQRIWKH'/&LVGDPDJHGRUKDVLQVXႈFLHQWSRZHUSOHDVHIROORZWKH
either of the following methods to proceed:
a) Cigarette Lighter cable
b) Battery Clamps Cable
