© Adolf Thies GmbH & Co. KG · Hauptstraße 76 · 37083 Göttingen · Germany
021197/07/19
Tel. +49 551 79001-0 · Fax +49 551 79001-65 · [email protected] ·
Seite 11 von 20
Article-No.
5.4103.31.000
Figure: Instrument with connected cable.
Cable type: 7 x 0,25LIYCY, UV- resistant, Ø 6mm.
Figure status: instrument power-off or precipitation „yes“.
5 Taking into Operation
After the electrical connection has been established, and the case has been screwed, the
operating voltage can be switched on. The setting of the relay output is undefined after
switching on the operating voltage and shows „no precipitation“.
6 Maintenance
The device is maintenance free.
Cleaning:
The pollution and the pollution level is dependent on the location. Therefore, we recommend
the unit be checked at appropriate intervals and cleaned if necessary.
For the cleaning should use a damp cloth without chemical cleaning agents are used.
Remark:
The housing is coated in the front section and in the sensor area. This coating must not be
damaged.
We recommend to clean (rinse) the instrument only with water, and to blot it with a soft cloth,
if necessary. Please take care that no water gets into the instrument. Excessive rubbing
might remove the coating.
