MAINTENANCE
This appliance needs little maintenance other than cleaning. All parts should be cleaned using
warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders. When
cleaning the burner ring it is essential to ensure that the holes do not become blocked.
The control knobs are a push fit and can be removed for cleaning. They are interchangeable
without affecting the sense of operation.
THIS APPLIANCE MUST NOT BE MODIFIED OR ADJUSTED UNLESS AUTHORISED AND
CARRIED OUT BY THE MANUFACTURER OR HIS REPRESENTATIVE.
NO PARTS OTHER THAN THOSE SUPPLIED BY THE MANUFACTURER SHOULD BE USED
ON THIS APPLIANCE.
Who to Contact
For service, please contact your authorised local Service Agent giving full details of the model,
serial number and date of purchase.
Manufactured by:
THETFORD Limited.
Unit 19 Oakham Drive,
Parkwood Industrial Estate,
Rutland Road,
Sheffield. S3 9QX. England.
•
DO NOT
store or use gasoline or other flammable vapours, liquids or
items in the vicinity of this or any other appliance.
•
DO NOT
spray aerosols in the vicinity of this appliance while it is in
operation. Where this appliance is installed in marine craft or in caravans,
it shall not be used as a space heater.
•
NEVER
check for leaks with an open flame
SERVICING
ALL SERVICING MUST BE CARRIED OUT BY AN AUTHORISED PERSON. AFTER EACH
SERVICE THE APPLIANCE MUST BE CHECKED FOR GAS SOUNDNESS
Details of the injector orifice size are provided within the specification tables on pages 2,3 & 4.
To verify the system is operating at the correct pressure a pressure test point is provided on the
gas manifold, located below the control panel. The pressure is measured with Semi Rapid
burner on high flame and with an inlet pressure of 2.75 kPa (Propane).
1. Remove hob
•
Isolate the gas supply and disconnect inlet pipe
•
Disconnect 12v power wires to spark generator.
•
Release the worktop clamps from beneath the appliance - see Figs. 12, 13 & 14 for
clamping method details. Lift and place the hob onto a suitable surface.
14
Содержание 162 series
