5
For more information about our products and how to contact us, please visit thermopatch.com
3. Assembly and installation
3.1 Assembly and installation
1. Unpacking:
• Remove the wooden protective crate.
• Use a 10 mm spanner to remove the four screws with which the machine is screwed to the pallet
• Lift the machine onto the work table by means of the tongs that are mounted.
• Place the foot extender as shown in the photo below
2. Electrical installation (1)
Take the NL-35 v.3 out of the box and place the machine on a stable work table in the vicinity of a grounded
socket. The NL-35 v.3 is connected to the power supply (230 V alternating current) with the supplied mains
cable. The NL-35 v.3 is grounded and equipped with two fuses type T 16 A.
3. Pneumatic installation (2)
In order to be able to work with the NL-35 v.3 without problems, it is very important that you work with
clean, dry air that is offered at a minimum of 3 bar up to a maximum of 8 bar.
The supplied water separator / pressure regulator is only an additional protection for the machine.
The user must ensure that the air pressure does not exceed 8 bar. Connect an air tube with a diameter of
6 mm to the locally provided air pressure system and connect it to the water separator / pressure regulator
of the NL-35 v.3.
ATTENTION!
Mount the foot extender BEFORE loosening the transport screws.
Mount the foot
extender behind
on the right
2. compressed
air connector
1. power cable
connector
