ThermoFLUX Minitherm AQUA, Руководство пользователя и по обслуживанию

Страница: 10 / 44

Minitherm AQUA
10
2.8 Obligatory informing
Everyone who operates with the stove must read the instructions before using it, in
particular, the chapter ‘’Safety Instructions’’. This applies especially to persons who
occasionally work on a stove, for example, cleaning and maintaining stoves. This
manual should always be kept near the installed stove.
Pay particular attention to the applicable local standards and guidelines.
2.9 Local standards
All local laws must be respected during installation, as well as standards and
norms that are in force in the country where the stove is installed even though
it is not listed in this manual.
During the first installation of the stove or in the event of changes on central heating
system, it is necessary to inform the competent authority in charge for control, and
provide all the necessary permits.
2.10 Safety instructions for the heating room
The heating room must be made according to current regulations, especially regarding
fire protection. Storage of flammable materials, cleaning agents and similar materials
must not be stored in the boiler room. The stove should not be exposed to colds or
freezing temperatures. Extreme low temperatures can cause malfunction and
unexpected behavior of electronic components.
The room where the stove is installed must be frost-resistant.
2.11 Fresh air supply
For combustion of pellets and normal work the stove needs fresh air. The room in
which the stove is installed must have an opening for fresh air supply. The
recommended minimum dimension is 30x15 cm.
2.12 Safety devices
The stove is equiped with safety devices that in case of unexpected
situations stop the power supply and therby stop the operation stove.
Microprocessor control on the stove:
Intervenes directly and turns off the stove
until it cools down. In case of failure of exhaust fan, malfunction of the dispenser
engine, or failure of the ignition.
Fuse F4A 250V: Fast fuse, protects the stove from large voltage changes of electricity
and short circuits inside the stove.