ThermoFisher Scientific Vanquish VC-D11, Руководство по эксплуатации, Страница: 69 / 192

5 • Installation
Diode Array/Multiple-Wavelength Detectors (VC-D11, VC-D12, VF-D11)
Operating Manual Page 69
Follow these steps
To set up the flow connections and complete the installation of the
device, follow these steps:
1. Set up the flow connections to the flow cell (see Flow Connections
to the Flow Cell ( } page 74) ).
2. Connect the device to the drain system (refer to the Vanquish
System Operating Manual ).
For installation instructions, guidelines, and handling recommendations,
see
Connecting Fittings, Capillaries, and Tubing ( } page 72) .
5.8.2 Guiding Capillaries and Tubing Through the System
Flow connections between the modules of the Vanquish system are
guided through either the tubing chase in the devices or the guide holes
or capillary clips of the devices.
Tubing Chase, Tubing Guide, Tubing Bracket
To guide certain tubes and lines (solvent tubing, wash liquid tubing,
detector waste line) from the top module to the bottom module in the
Vanquish system stack, the stackable modules have a tubing chase on
the inside right.
The tubing chase provides four tubing guides. Each guide can hold up to
three tubes or lines.
In each module, push the tube (or line) into the appropriate guide.
Figure 15: Tubing chase with tubing guides (left: view from inside, right:
view from top)
No. Use for
1 Solvent tubing (up to three solvent lines)
2 Solvent tubing (up to three solvent lines)
3 Wash liquid tubing (seal wash, autosampler needle wash)
4 Detector waste line