ThermoFisher Scientific HERASAFE 2030i Series, Руководство по эксплуатации

Страница: 39 / 173

Herasafe 2030i / Maxisafe 2030i
50155215 | 29
Unit Description |
Chapter 4
Working Area
The standard equipment comprises the segmented workplate for the Herasafe 2030i and
the one-piece workplate
for the Maxisafe 2030i. Special workplates are available as
optional accessories.
The workplates or workplate segments are placed onto the frame above the workspace
drain pan.
Figure 13 Working Area on the Workplate, Armrests
The working area A for perfect material protection extends over the entire width B and
depth C of the workplate [1]. The two arm rests [3] are positioned at a distance D (20 cm)
to each other centrically on the workplate [1] or on the workplate segments. The armrests
are installed to the second perforation line [2] of the workplate.
SmartPort
Installation of low voltage cables and hoses:
The low voltage cables and hoses that are used must be designed for the purposes
intended. Hoses have to be < 10 mm (Ø 10 mm). The opening in the rubber grommet of
the SmartPort should be maintained as small as possible so as not to compromise the
efficiency of containment. Always introduce hoses from the outside inwards and apply
only little force. Make sure that the seal is seated correctly! The SmartPort is intended for
single use and may not be reused.
The 2 armrests (3) are safety relevant component parts!