THERMOBILE IMAC 2000 PELLET, Руководство пользователя

Страница: 10 / 24

THERMOBILE INDUSTRIES BV
INSTRUCTIONMANUAL PELLETHEATER
10
A room thermostat can be connected to the control cabinet. It can be used to control the
temperature in the room to be heated.
The external auger transports the pellets from a pellet container to the burner. The controller
board contains a microprocessor system that tests main safety components, monitors and
regulates the burning procedure, starts and stops the burner automatically according to the
heater temperature. A warm air element (electrical igniter) ignites the pellets. The start
procedure is designed to create a quick and smoke free ignition.
The burner starts burning when the heater temperature cools down and heater thermostat
switches on. Burner runs until the pre-set maximum heater temperature (switch-off
temperature) has been reached. After that burner stops safely burning procedure and goes
to waiting (stand by) status.
Main supply interruptions (blackouts) are taken care of by the control system. After a main
supply interruption burner stops safely burning and goes to stopped status. When a blackout
occurs, the burner ends safely burning process. If there is a safety risk, the burner switches
off.
2.3 Main components of the convector heater (Fig. 5)
A Flue connection
B Lifting hook
C
Operating panel
D Socket
E Identification plate
F
Connection for room thermostat
G Socket for power connection
H Fan motor
I
Air inlet
J Fan
K
Burner room
L Heat exchanger
M Shaft for lifting purposes
N Ash auger motor
O Ash auger
R
Burner
S Auger switch (fig.xx A )
T Hot-air outlet
U
Armature nut
V Thermostat sensor
2.4 Burner (Fig. 3)
Make sure to read the burner Manual carefully before using the convector heater
With this heater is it is easy to take out the burner for cleaning and servicing. To take out the
heater disconnect B and unscrew C.