Thermo 49i, Инструкция по эксплуатации, Страница: 237 / 276

C-Link Protocol Commands
Measurement Configuration
Thermo Fisher Scientific Model 49
i
Primary Standard Instruction Manual B-29
The RLE encoding consists of a 0 followed by an 8-bit count of consecutive
0xFF bytes. The following 'c' code will expand the incoming data.
To convert this data into a BMP for use with windows, it needs to be turned
into a 4BPP as that is the smallest windows can display. Also note that BMP
files are upside down relative to this data, i.e. the top display line is the last
line in the BMP.
sc
screen
This command is meant for backward compatibility on the C series. Screen
information is reported using the “iScreen” command above.
Send: screen
Receive: screen This is an I series Instrument. Screen Information
not available
Measurement
Configuration
range
high range
low range
Void unpackDisplay ( void far* tdib, unsigned char far* rlescreen )
{
int i,j,k;
unsigned char far *sc4bpp, *sc2bpp, *screen, *ptr;
ptr = screen = (unsigned char far *)malloc(19200);
//RLE decode the screen
for (i=0; i<19200 && (ptr - screen) < 19200; i++)
{
*(ptr++) = *(rle i);
if (*(rle i) == 0)
{
unsigned char rlecount = *(unsigned char *)(rle ++i);
while (rlecount)
{
*(ptr++) = 0;
rlecount--;
}
}
else if (*(rle i) == 0xff)
{
unsigned char rlecount = *(unsigned char *)(rle ++i);
while (rlecount)
{
*(ptr++) = 0xff;
rlecount--;
}
}
}