Thermo 49i, Инструкция по эксплуатации, Страница: 218 / 276

C-Link Protocol Commands
Measurements
B-10 Model 49
i
Primary Standard Instruction Manual Thermo Fisher Scientific
These commands report the measured O
3
concentrations when operating in
single range, or high and low O
3
when operating in dual or auto range
mode. The example that follows shows that the O
3
concentration is 67.2
ppb.
Send: o3
Receive: o3 6720E-2 ppb
flow a
flow b
These commands report the sample flow in Cell A and Cell B. The example
that follows reports that the current sample flow in Cell A is 0.608
liters/minute.
Send: flow a
Receive: flow a 0.608 l/m
o3 lamp temp
This reports the current ozonator lamp temperature. The example that
follows reports that the current ozonator temperature is 68.7
°
C.
Send: o3 lamp temp
Receive: o3 lamp temp 068.7 deg C
lamp
This reports the current photometer lamp setting. The example that follows
reports that the lamp setting is 72.9%
Send: lamp setting
Receive: lamp setting 72.9%
set lamp
ddd.d
This command sets the photometer lamp setting to ddd.d , where ddd.d is a
floating-point number representing a percentage of the photometer lamp
setting. The example that follows sets the photometer lamp to 75.5%
.
Send: set lamp 75.5
Receive: set lamp 75.5 ok
lamp setting
This reports the current photometer lamp setting. The example that follows
reports that the lamp setting is 72.9%
Send: lamp setting
Receive: lamp setting 72.9%
lamp temp