Thermo Scientific thermoscientific Vanquish UHPLC System, Руководство по эксплуатации

Страница: 78 / 148

5 • Installation
Page 78 UHPLC System
Operating Manual
5.6 Turning On the System
NOTICE
Before turning on power to the Vanquish system, verify that any
shipping locks have been properly loosened or removed to avoid
damage to the system. Refer to the Operating Manual for each module
for information on shipping locks that need to be removed.
TIP
Before turning on the power to a Vanquish system module for the first
time, verify that the chromatography software is installed on the data
system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows™ operating system
can detect the device.
To turn on the power to the system, follow these steps:
1. Check that the power button on the front left of the Vanquish
system base (system power button) is pressed in. If the power
button stands out, press the power button to turn on the power on
the system base.
2. Turn on each module with its main power switch. Verify that the
autosampler is turned on before the pump flow is on and pressure
builds up.
Turn a module off with the main power switch, when instructed to do
so, for example, during maintenance. Pressing the system power button
will not be sufficient to turn off the power to the module completely.
See also
2 Power On/Off Control ( } page 86)