Thermo Scientific Thermo Scientific Vanquish VC-D40, Руководство по эксплуатации

Страница: 54 / 174

5 • Installation
Page 54 Variable Wavelength Detectors (VC-D40, VF-D40)
Operating Manual
No. Description
5 System Interlink port
Allows power on/off control for the detector from the Vanquish system
base and device communication and synchronization between the detector
and other modules in the Vanquish system.
For example, the interconnection between autosampler and detector
automatically enables direct synchronization of sample inject and data
acquisition start in the detector. As a result, the synchronization improves
the retention time reproducibility.
6 Digital I/O ports (Dig I/O )
Allow exchange of digital signals with external instruments
Each digital I/O port provides one input and one relay output. For
connection and pin assignment information, see
Digital I/O ( } page 166) .
7 USB hub ("A"-type connector)
Allows connection to other modules in the Vanquish system
8 USB (Universal Serial Bus) port ("B" type connector)
Allows connection to other modules in the Vanquish system or the
computer on which the data management system is installed, such as the
Chromeleon software
TIP Thermo Fisher Scientific recommends using the USB ports only as
described above. If the USB ports are used for any other purpose,
Thermo Fisher Scientific cannot ensure proper functionality.
Follow these steps
NOTICE
• Never use defective communication cables. If you suspect that a
cable is defective, replace the cable.
• To ensure trouble-free operation, use only the cables provided by
Thermo Fisher Scientific for connecting the device.
1. Place the device in the system as required by the system
configuration. For details, refer to the Vanquish System Operating
Manual .
2. Connect the required interface cables to the device. For information
about how to connect the device to other modules in the Vanquish
system or to the chromatography data system computer, refer to
the
Vanquish System Operating Manual .
3. Connect the power cord (see Connecting the Power Cord
( } page 55) ).