Thermo Scientific Sorvall ST Plus Series, Инструкция по эксплуатации

Страница: 73 / 172

3-41
Graphical User Interface
3. 7. Display
Tapping the Display button on the “Settings” screen takes you to the “Display” screen. The “Display” screen
offers a stack of buttons. These buttons allow for customizing general display properties for all screens of the
Graphical User Interface to suit your needs, altering the factory default settings. The options on the “Display”
screen include:
ƒ
“Brightness”
ƒ
“Language”
ƒ
“Auto Date/Time”
ƒ
“Date”
ƒ
“Time”
ƒ
“Region”
ƒ
“Unit Name”
ƒ
“Screen Sensitivity”
ƒ
“Screen Calibration”
The “Display” screen holds more options than would fit on one screen. Therefore, it has a scrollbar on the right
side of the button stack.
Figure 3–64: Settings -> Display Screen
By tapping the scrollbar and dragging, you can display the options that are currently hidden.
Selections are made by dragging a slider or tapping
drop-down lists on the screen. You may change one,
several, or all of the options before confirming your selections with the Save button.
3. 7. 1. Brightness
If the ambient lighting conditions make the centrifuge’s display unit difficult to read, you can change the
brightness directly on the “Display” screen. This is achieved by tapping on the “Brightness” slider and dragging.
Figure 3–65: Settings -> Display Screen -> Brightness
Proceed as follows to change the brightness:
1. Tap the Settings icon on the navigation bar.
2. Tap the
Display
button on the “Settings” screen.
The “Display” screen appears.
3. Tap the Brightness slider and drag to the left to decrease and or to the right to increase. Alternatively, you
can tap the or buttons on both sides of the slider to decrease or increase.
The screen dims down or brightens up as you drag the slider.
If you make any changes, the Save button at the bottom of the screen is highlighted.
4. When you have finished adjusting brightness, tap the Save button to save the new brightness setting for
the display unit.