Smart-Vue Pro Duo / Quatro User Guide
Getting Started | 15
To power your data logger using the adapter:
1. Plug the AC adapter into the electrical power outlet.
2. Insert the adapter’s cable into the USB port located on
the side of the Smart-Vue Pro Duo/Quatro data logger,
installing the 3.6 V batteries as a back-up.
Ready Screen/Regional
Settings for Smart-Vue Pro
LoRaWAN Frequency
After you turn on the power of the Smart-Vue Pro Duo/Quatro
data logger, specify your geographical region to determine
the Smart-Vue Pro LoRaWAN frequency used for wireless
communication. You cannot not proceed beyond this screen
unless you confirm your geographical location even if you only
intend to use bluetooth connectivity.
Figure 13. Select region to set the correct
LoRaWAN frequency
1. Tap the up/down arrows (
or
) to select your region
(this only assigns the Smart-Vue Pro LoRaWAN radio
frequency).
2. Tap
Save
to continue.
3. The Smart-Vue Pro ready screen is displayed showing
waiting for configuration via the web or Smart Connect
mobile application, depending on your needs. This
screen is displayed whenever there is no active data
logging session.
Figure 14. Smart-Vue Pro ready screen
CAUTION:
Do not remove batteries from your
data logger even while using the adapter. The
batteries are also used as a backup for the AC
adapter with the power supply switching
automatically to the batteries in case of a power
failure. You may change the batteries without
losing any data as long as the AC adapter is
plugged in. You may also change batteries one
after the other to maintain power during the
process.
Note:
If you are using your data logger with
Smart-Vue Pro LoRaWAN connectivity, you
must use the
Smart-Vue Pro web
application
to configure and start data
logging and interact with your Smart-Vue
Pro Duo/Quatro data logger.
Note:
If you are using your data logger with
bluetooth connectivity, you must use the
Smart Connect mobile application
to
configure and start data logging and
interact with your Smart-Vue Pro
Duo/Quatro data logger.