Thermo Scientific
Orion Star
™
LogR Meter
Quick Start Guide
Preparation
1. Power adapter - Select the appropriate wall socket plug and slide the plug
plate into the groove on the back of the adapter.
See A
.
Batteries - Select four AA Alkaline batteries. Confirm that the meter is powered
off and remove the battery cover. Orient and insert the batteries as depicted in
the battery compartment housing. Replace the cover.
See B
.
2. Prepare the electrode according to the directions in the electrode instruction
manual. In general, these steps include:
• Gently remove the protective cap from the sensing element and save for
storage.
• For refillable electrode, remove the fill hole cover and fill the electrode with
the appropriate fill solution.
See C
.
• Soak the electrode in the storage solution specified in the electrode
instruction manual.
See D
.
3. Meter connections - Connect the power adapter to the meter and then to the
wall socket.
See E
. Connect the ISE electrode to the BNC input on the meter.
See F
. Connect the stir probe to the stir jack input on the meter.
See G
.
NOTE:
Make sure that all unused inputs on the meter are covered with the
black caps.
Meter Overview
1. To power on the meter, press the
key
2. In the measurement screen, press the
key to change the value on the top
display line to:
i. pH, RmV, mV, temperature or a blank line
ii. pH, RmV, mV, ISE, temperature or a blank line for the Cat. No. 3115000.
3. To escape out of any meter function, press and hold the
key until the
meter returns to the measurement mode.
4. The middle display line is only active when the LogR setting is in use. Press
the
to choose the top or middle display line. The will point to the
selected line. When the middle line is selected, press the
key to show the
resistance of the glass pH bulb or to show a blank line.
A
B
C
D
E
F
G
Key Description
power
up arrow
line select
view log
calibrate
down arrow
setup
stir
measure
digits
Meter Connections
For the complete Orion Star
™
LogR™ User’s Guide visit www.thermo.com/water
Stirrer Jack
DO AUTO-STIR
or Stir Probe
™
Pin Tip
Reference
BNC
pH/ISE
8 Pin MiniDIN
ATC
RS232
Ground
Power
264906-001 RevA
QS-LogR-E 0110
