Thermo Scientific OGS 100, Руководство по эксплуатации

Страница: 20 / 110

Installation
Space Requirement
3-4 Heratherm Thermo Scientific
Space Requirement
For built-in units following clearances should be kept:
A, B, C and D see Operating Instructions of the unit.
Installation Built-in Units
When installing the oven, make sure that the installation and supply connections remain
freely accessible.
The specified side clearances represent minimum distances.
Fig. 3
E (mm/inch) F (mm/inch) G (mm/inch) H (mm/inch)
100 / 4 50 / 2 80 / 3.2 30 / 1.2
IGS Clearances, as fig. 3, without exhaust hose.
IMH/IMH-S Clearances, as fig. 3, close air port with plug, supplied with the unit.
OGS/OMS Clearances, as fig. 3, with additional space to operate to air slide, with air exhaust
system and exhaust hose Ø 40 mm (1.58 in)/1.5 m (59 in) (original Thermo
accessory), shortened to required length, installed according to fig. 1 and 2.
OGH/OGH-S
OMH/OMH-S Clearances, as fig. 3, with air exhaust system and exhaust hose Ø 40 mm (1.58 in)/1.5
m (59 in) (original Thermo accessory), shortened to required length, installed accord-
ing to fig. 1 and 2, Operating temperature up to max. 250 °C (482 °F).
After connecting the built-in unit to the electrical
power supply, avoid damaging the power cord, then
sliding into the installation position.