Thermo Scientific Dionex, Руководство оператора

Страница: 67 / 228

3 • SP Sample Preparer Description
Doc. 065250-06 03/2020
55
7. Plug the cable into the Pressure connector on the main SP electronics board.
8. Plumb the pressure transducer inlet and outlet ports as required for the
application. (There is no prescribed flow direction; liquid can enter and leave
the pressure transducer from either side.)
9. Close and secure the SP service door.
10. If you removed the SP from the AE rear panel:
a. Lift up the SP, align the four hooks on the rear of the SP with the
mounting rails on the AE rear panel, and hang the SP on the rails.
b. Replace any modules that were removed from the lower shelf of the AE.
c. Replace the two access panels on the exterior of the AE.
11. Plug in the power cord and turn on the power.
12. Open the Chromeleon Instrument Configuration Manager and open the SP
Properties dialog box. The Pressure Transducer check box is enabled on
the Pumps/Motors page.
13. Save the configuration.
14. Calibrate the pressure transducer (see Section 10.10 ).
Figure 3-34. Main SP Electronics Board: Pressure Transducer Connector
Pressure Sensor Connector