Thermo Scientific Dionex, Руководство оператора

Страница: 172 / 228

Dionex Integral Systems Operator’s Manual
160
Doc. 065250-06 03/2020
C.3 Installing the TTL and Relay Breakout Boards
NOTE Before starting this procedure, install the SP TTL and
Relay Kit (see Section C.1 ).
If the SP is installed inside an AE—or is mounted on the
side of an AE—also install the AE TTL and Relay Kit
(see
Section C.2 ) before proceeding.
C.3.1 Overview
These are the main steps in the installation procedure:
•
Connecting wires to the TTL and relay breakout boards
•
Plugging the breakout boards into their respective connectors on the
SP or AE
•
(Optional) Assigning TTL input control types
Additional items needed :
•
Phillips screwdriver
•
Multiconductor cables (see the specifications below) or individual
24 AWG or 22 AWG (0.51 mm or 0.65 mm) wires
NOTE Multiconductor cables are required for connections
to the hooded TTL and relay connectors on top of
the AE.
Multiconnector Cable Specifications
Number of conductors 25 (or fewer, depending on installation
requirements)
Size of conductors 24 AWG or 22 AWG (0.51 mm or 0.65 mm)
Outside diameter of cable 0.2 in to 0.5 in (5 mm to 12 mm)
Number of cables To connect to all pins: For each 25-pin D-sub
connector, use one 25-conductor cable or two
14-conductor cables.
If not all pins are required, you can use cables
with fewer than 25 conductors (for example,
12-conductor cables).