Thermo Scientific 5028i, Инструкция по эксплуатации, Страница: 325 / 330

Thermo Fisher Scientific Model 5028
i
Instruction Manual E-1
Appendix E
ESM Protocol Commands
This appendix provides a description of the ESM Protocol commands
(from the prior FH62 platform) that can be used to remotely control
a Model 5028 i instrument using a host device such as a PC or a
datalogger. ESM protocol may be used over RS-232, RS-485 or over
Ethernet. ESM functions can be accessed over Ethernet using TCP port
9884.
Up to three simultaneous connections per protocol may be made over
Ethernet.
Table E-1 through E-3 lists the ESM commands supported for the
Model 5028 i .
Table E–1. Read Commands for 5028
i
Command Description
C output of the dust mass concentration a in μg/m³ (actual mode)
CB output of the dust mass concentration b in μg/m³ (actual mode)
HT 24 h (daily) average concentration a [μg/m³]
HTB 24 h (daily) average concentration b [μg/m³]
JB temperature sampling head
JD temperature inside of the flow meter orifice a
JDB temperature inside of the flow meter orifice b
JF different pressure of the air flow measuring module a in Pa
JFB different pressure of the air flow measuring module b in Pa
JG low pressure suction chamber a
JGB low pressure suction chamber b
JH barometer in hPa
JI air flow sampling head a
JIB air flow sampling head b
JJ norm air flow a (273K, 1013hPa)
JJB norm air flow b (273K, 1013hPa)
JO air flow rate a regulation 0…100%
ESM Commands
Supported