Thermo Scientific 5028i, Инструкция по эксплуатации

Страница: 285 / 330

C-Link Protocol Commands
Measurement Configuration
Thermo Fisher Scientific Model 5028
i
Instruction Manual B-45
temp comp
This command reports whether temperature compensation is for actual
or standard conditions. The following example shows the temperature
compensation is standard.
Send: temp comp
Receive: temp comp std
set temp comp selection
selection = | act | std |
These commands turn the temperature compensation to either actual
or standard conditions. The following example turns the temperature
compensation to actual.
Send: set temp comp act
Receive: set temp comp act ok
temp std a/b
This command reports the standard temperature. The following example
reports that the standard temperature is 18 °C.
Send: temp std a
Receive: temp std a 18 degC
Send: temp std b
Receive: temp std b 18 degC
set temp std a/b
value
This command sets the standard temperature to value , where value is a
floating-point number representation of standard temperature between
0 to 25 °C. The following example sets the standard temperature to 15
°C.
Send: set temp std a 15
Receive: set temp std a 15 ok
Send: set temp std b 15
Receive: set temp std b 15 ok
temp th a/b
This command reports the heater temperature threshold for the sample.
The following example reports that the temperature threshold is 30 °C.
Send: temp th a
Receive: temp th a 30 degC
Send: temp th b
Receive: temp th b 30 degC