Thermo Scientific 5028i, Инструкция по эксплуатации, Страница: 282 / 330

C-Link Protocol Commands
Measurement Configuration
B-42 Model 5028
i
Instruction Manual Thermo Fisher Scientific
set flow target a/b
value
This command sets the flow to value , where value is a floating-point
number representation of flow between 1 to 20 LPM. The following
example sets the flow to 16.67 LPM.
Send: set flow target a 16.67
Receive: set flow target a 16.67 ok
Send: set flow target b 16.67
Receive: set flow target b 16.67 ok
ht control a/b
This command reports the current status of the heater (off, RH
threshold, or temp threshold). The following example reports that the
heater is RH threshold.
Send: ht control a
Receive: ht control a RH
Send: ht control b
Receive: ht control b RH
set ht control selection a/b
selection = | off | rh | temp |
This command sets the heater to off, RH threshold, or temp threshold.
The following example sets the heater to temp threshold.
Send: set ht control temp a
Receive: set ht control temp a ok
Send: set ht control temp b
Receive: set ht control temp b ok
mass limit
This command reports the current filter mass limit. The following
example reports that the mass limit is 1,500 mg.
Send: mass limit
Receive: mass limit 1500
set mass limit value
This command sets the filter mass limit to value , where value is a
floating-point number representation of mass limit between 0.5 to 5.0
mg or 500 to 5,000 µg. The following example sets the mass limit to 1.0
mg.
Send: set mass limit 1.0
Receive: set mass limit 1.0 ok