Thermo Scientific 5028i, Инструкция по эксплуатации

Страница: 156 / 330

Preventive Maintenance
Replacement Parts
5-2 Model 5028
i
Instruction Manual Thermo Fisher Scientific
See the “ Servicing ” chapter for a list of replacement parts and the
associated replacement procedures.
WARNING
If the equipment is operated in a manner not specified by
the manufacturer, the protection provided by the equipment may be
impaired.
s
Clean the outside case using a damp cloth being careful not to damage
the labels on the case.
Equipment Damage
Do not use solvents or other cleaning products to
clean the outside case.
s
The inlet assemblies can include a TSP inlet, a U.S. EPA compatible
PM
10
inlet, or a Digital PM
10
or PM
2.5
inlet. Cleaning schedules and
routine maintenance of assembly components should be in accordance
with a good quality assurance plan.
In general, it is recommended that the inlet assemblies be cleaned on
a quarterly interval with mild soap solution, a thorough rinsing, and
dried with a lint free cloth. If any impaction surfaces require impactor
grease, it should be applied prior to reassembly. Furthermore, a general
inspection, and replacement as necessary, of o-rings should be done.
Equipment Damage
Some internal components can be damaged by
small amounts of static electricity. A properly grounded antistatic wrist
strap must be worn while handling any internal component. For more
information about appropriate safety precautions, see the “ Servicing ”
chapter.
s
The water collector bottle located on the PM
10
inlet should be inspected
at least every five sampling days ( Figure 5–1 ). Remove any accumulated
water, clean the interior of the bottle, inspect the seals, and replace the
bottle in the holder.
Replacement Parts
Cleaning the Outside
Case
Cleaning the Inlets
U.S. EPA PM
10
Inlet