Thermo Scientific 49i, Инструкция по эксплуатации

Страница: 289 / 314

C-Link Protocol Commands
I/O Configuration
Thermo Fisher Scientific Model 49
i
Instruction Manual B-41
dig in
This command reports the status of the digital inputs as a 4-digit
hexadecimal string with the most significant bit (MSB) being input 16.
Send: dig in
Receive: dig in 0xff7f
din channel
This command reports the action assigned to input channel and the
corresponding active state. The example that follows reports the input 5 to
be assigned an index number 9 corresponding to action of “analog outputs
to zero” with the active state being high.
Send: din 5
Receive: din 5 9 AOUTS TO ZERO high
set din channel index state
This command assigns digital input channel (1-16) to activate the action
indicated by index (1-35), when the input transitions to the designated state
(high or low). Use “list din var” command to obtain the list of supported
index values and corresponding actions.
Send: set din 1 3 high
Receive: set din 1 3 high ok
dout channel
This command reports the index number and output variable and the active
state assigned to output
channel. The example that follows reports the input
4 to be assigned an index number 11 corresponding to “general alarm” with
the active state being open.
Send: dout 4
Receive: dout 4 11 GEN ALARM open
set dout
channel index state
This command assigns digital output channel to be assigned to the action
associated with index , and assigns it an active state of state (open or closed).
Send: set dout 4 11 open
Receive: set dout 4 11 open ok
dtoa channel
This reports the outputs of the 6 or 12 digital to analog converters,
according to
Table B-11 . The example that follows shows that the DAC 1 is
97.7% full-scale.