Thermo King 920000, Руководство пользователя

Страница: 72 / 190

Electrical Maintenance
72
Field Test Procedure for
Multi-Temperature In-Cab TG-V
Controllers
Use tester P/N 204-831.
1. Connect the end of the tester marked “DUAL”
to the multi-temperature controller.
2. Power up the controller by connecting the
tester leads to a 12 volt dc power supply.
3. Press the controller’s
O
N
key to display all
segments.
NOTE: Both screens must be on to properly
test the multi-temperature controller.
a. The Whisper icon must be displayed. If
not, press the
W
HISPER
M
ODE
key. Alarm
Code 19 will be recorded if the Whisper
icon is not displayed.
b. If the Alarm icon is displayed, press the
S
ELECT
key to display the alarm and press
the
E
NTER
key to clear the alarm.
4. Press the
S
ELECT
key to display the setpoint(s)
and adjust the setpoint(s) to 80 F (27 C). Both
setpoints must be adjusted to 80 F (27 C) to
properly test the multi-temperature controller.
NOTE: The controller must be set to display
temperatures in the Fahrenheit scale. The
test WILL NOT work if the controller is
displaying temperatures in the Celsius scale.
Refer to the Controller Operating and Setup
Manual for information about changing the
displayed temperature scale.
5. With the setpoint of 80 F (27 C) displayed on
the screen, press the following keys
simultaneously:
•
S
ELECT
key.
•
U
P
A
RROW
key.
•
W
HISPER
M
ODE
key.
6. The display will read “FT”. The
multi-temperature controller will display “FT”
on the left screen.
a. All other icons will be Off.
b. The red, Power Cord LED will begin to
flash on and off.
c. All icons will then turn On for a few
seconds.
d. Then the display will count from 1 to 15
(left screen on multi-temperature
controller).
e. The display will then read PS for pass, or
FC for fail.
f. Press the
O
FF
key to exit the test.
1. Tester Side “DUAL” Connections
2. Multi-Temperature Controller
Figure 26: Connecting Tester to Controller
1
2