Thermo King 098916, Руководство по обслуживанию

Страница: 68 / 196

Operating Instructions
67
Misc. Functions Menu
The Misc. Functions menu displays a list of
functions that identifies trips and determines how
the controller records and displays operating
information. The following functions are
available:
• Date Time: Sets the controller time and date.
• Status: Displays status messages. See the
complete list of all status messages and the
corrective action listed in the Diagnosing and
Troubleshooting Section in the back of the
manual.
• Run Time: Displays and sets operating hours
for the unit and components.
• Program Version: Displays the current
software version loaded in the controller:
Controller (CTRL), EPROM and program
serial numbers (SER NO).
NOTE: The Controller Label on the side of
the control box shows the controller serial
number and the EPROM version.
• Cargo Data: Sets important trip information
about the container and the load in the
controller.
• C/F Mode: Sets the temperature value (Celsius
or Fahrenheit) the controller uses to record
and display temperature (including historical
data).
A complete listing of the controller operating
menu is located on an 11” x 17” fold out on the
last page of this manual.
View Misc. Functions Menu
With the
U
NIT
O
N
/O
FF
switch
O
N
and the LCD
display showing the standard display (setpoint):
1. Press the F2 or F3 key to enter the menu list.
Press F2 or F3 key to scroll through Main
menu until [MISC. FUNCTIONS] appears in
LCD display.
2. Press the F4 key to access the Misc. Functions
menu. The first command in the submenu
appears in the LCD display: Date Time.
Figure 38: Misc. Functions Menu
3. Press the
F2
or
F3
key to scroll to the desired
function:
• [DATE TIME]
• [STATUS]
• [RUN TIME]
• [PROGRAM VERSION]
• [CARGO DATA]
• [C/F MODE]
4. Press the F4 key to access the function
selected.
ALARMS
DATA
RMM STATE
CONFIGURATION
MISC FUNCTIONS
Misc. Functions
Menu
- Date Time
- Status
- Run Time
- Program Version
- Cargo Data
- C/F Mode
MAIN MENU
DATALOGGER
COMMANDS
NOTE: All screens are NOT
present on all units. The
screens that display on the
controller are determined by
the Controller Software
settings and the options
installed on the unit.