Thank you for your preference. You have chosen a very useful and tested device.
Read carefully the following instructions as proper installation and use can secure long life expectancy.
Organised maintenance SERVICE is always at your disposal at the following numbers
THESSALONIKI: 2310-323223 – 307903 ATHENS: 210-3454821 - 346111
PATRAS: 2610-277063 – 623144 NICOSIA: 003572-778743 - 775586
INSTALLATION AND USE INSTRUCTIONS
GENERAL INSTRUCTIONS
A free-flow heater makes hot water run freely out of the shower head without any interference switches. The
switch for operating the device must be always installed before the inlet union.
CHOOSE A MULTI-TURN SWITCH FOR EASY HANDLING.
The correct position is when the inlet-outlet water union faces the floor (fig. 1, 2). The minimum working
pressure is 2 bar. Two electrical switches enable us to adjust heating capacity depending on the season.
Finally, it collaborates effectively with the solar water heater.
INSTALLATION - PLUMBING CONNECTION
K3p THERMITRON is provided with water by the water supply network at a pressure of 2 to 8 bar. In the
bathroom, they are placed on the wall, at a height of around 1.60 meters from the floor and are connected
with pressure spirals from the shower head of the tub or shower (SEE FIGURE 1) or by providing a network
from another point of the bath with the use of a water switch (SEE FIGURE 2).
NOTE: Before connecting the device to the water supply network, let some water run to clean the pipes.
ELECTRICAL CONNECTION
The electrical connection to the network is performed via a flexible tripolar cable, with a cross-section
depending on the indicated power of the device (SEE TECHNICAL DATA TABLE), and through an all-pole
switch with contacts separated by at least 3 mm. The wires in the terminal strip must be screwed correctly
to avoid damage due to poor contact.
FINISHING THE INSTALLATION
After installation is complete and the cover of the device is closed, drag the two switches 2-3 times up and
down and set the switch to OFF position. Then turn on water to run out of the shower head for a few seconds
and the device is now now ready for use.
