Thermics LUNA 2T, Инструкция по установке, техническому обслуживанию и ремонту

Страница: 10 / 40

10
LUNA 2T | SAFETY REGULA
TIONS
2 Safety regulations
DANGER!
The machine has been designed and built according to appropriate safety standards.
Before using the machine, carefully follow all the precautions and instructions provided
in the manual to avoid accidents.
2.1 General safety rules
The use of products that use electricity and water involves compliance with certain basic safety rules
such as the ones provided below:
• Children and unattended disabled persons are not allowed to use the machine.
• Do not touch the machine if you are barefoot and have wet or damp body parts.
• Any cleaning operation is prohibited without first disconnecting the power supply by turning
the main switch of the system to "off".
• It is forbidden to modify the safety or adjustment devices without the authorisation and
instructions of the machine manufacturer.
• It is forbidden to pull, disconnect or twist the electrical cables coming out of the machine, even
if it is disconnected from the power supply.
• It is forbidden to open the access doors to the internal parts of the machine, if the system has
not been switched off by means of the main switch.
• It is forbidden to climb on the machine with your feet, sit and/or lean against any type of
object.
• It is forbidden to spray or throw water directly on the machine.
• The packaging material (cardboard, staples, plastic bags, etc.) may not be dispersed or left
within the reach of children, as it may be a potential source of danger.
• Observe the safety distances between the machine and other equipment or structures to
ensure sufficient access space to the unit for maintenance and/or servicing as indicated in
this manual.
• Power supply of the machine: the machine must be powered by means of electrical cables
with a section suitable for the power of the unit and the power supply voltage values must
correspond to those indicated for the respective machines; all the machines must be connected
to earth as per the regulations in force in the various countries.
• The hydraulic connection must be carried out according to the instructions in order to ensure
the correct operation of the machine.
• During the cold season, if the machine is not working, empty all the hydraulic circuits of the
machine to prevent them from freezing.
• Handle the machine with the utmost care and avoid damaging it.
• Glycol solution: the heat exchangers' antifreeze alarms are set based on the mixture declared
at the start-up. Breakages due to inadequate mixing or mixture not maintained over time are
not covered by the manufacturer's warranty.
• Installation room: some machine components generate heat during operation.
• The installation room must ensure adequate ventilation and proper dissipation of the heat
produced.