Thermann TH250GLE, Руководство по установке

Страница: 10 / 16

Thermann Installer's Manual
Electric Hot Water Tanks (Solar-Ready)
10
Solar Flow:
This port is used for the water line directed up to the
solar collectors to be heated. This line consists of the
following components in order from closest to furthest
away from the solar flow port:
• Circulation Pump
• Flow meter
• Check valve
• Collectors
1
2
5
3
6
4 7
All ports on an Thermann Australia storage tank are
of 20mm (3/4”) BSP. Teflon tape must be used to
seal any fitting. Copper olives must be used with all
compression fittings.
Inlet (Mains):
The mains line should consist of the following brass
components when installing:
• Duo valve
• Cold Water ECV
• Pressure Reducing Valve
• Four-Way Cross
The set of mains line valves can be purchased as a kit
from Thermann and provides the above components
with insulating jackets to streamline the installation
process.
THE TEMPERING VALVE MUST BE THE LAST
DOWNSTREAM COMPONENT INSTALLED BEFORE
THE HOT WATER REACHES THE HOUSE.
Figure 1 Thermann Storage Tank
THERMANN TANKS MUST BE INSTALLED IN
ACCORDANCE WITH AS/NZS 3500.4 AS WELL
AS ANY OTHER RELEVANT LOCAL/GOVERNMENT
STANDARDS.
Figure 2 Mains Line Valves
CAP THIS PORT WITH BRASS PLUG SUPPLIED
WHEN SOLAR COLLECTORS ARE NOT BEING
INSTALLED.
Thermann Installer's Manual
Electric Hot Water Tanks (Solar-Ready)
10
Solar Flow:
This port is used for the water line directed up to the
solar collectors to be heated. This line consists of the
following components in order from closest to furthest
away from the solar flow port:
• Circulation Pump
• Flow meter
• Check valve
• Collectors
1
2
5
3
6
4 7
All ports on an Thermann Australia storage tank are
of 20mm (3/4”) BSP. Teflon tape must be used to
seal any fitting. Copper olives must be used with all
compression fittings.
Inlet (Mains):
The mains line should consist of the following brass
components when installing:
• Duo valve
• Cold Water ECV
• Pressure Reducing Valve
• Four-Way Cross
The set of mains line valves can be purchased as a kit
from Thermann and provides the above components
with insulating jackets to streamline the installation
process.
THE TEMPERING VALVE MUST BE THE LAST
DOWNSTREAM COMPONENT INSTALLED BEFORE
THE HOT WATER REACHES THE HOUSE.
Figure 1 Thermann Storage Tank
THERMANN TANKS MUST BE INSTALLED IN
ACCORDANCE WITH AS/NZS 3500.4 AS WELL
AS ANY OTHER RELEVANT LOCAL/GOVERNMENT
STANDARDS.
Figure 2 Mains Line Valves
CAP THIS PORT WITH BRASS PLUG SUPPLIED
WHEN SOLAR COLLECTORS ARE NOT BEING
INSTALLED.