Thermal Solutions AMP 1000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 56 / 88

56
NOTICE NOTICE
1. These are suggested piping configurations. It is the installer's responsibility to
conform to local codes and ordinances for additional requirements.
2. Pressure relief valve rating shall not exceed pressure rating of any component
in the system.
3. Some piping components cannot be supported by the pipping. Refer to the
manufactures' installation instructions.
4. Circulation pump must be sized to overcome the pressure drop across the entire
loop.
!
Hot Water Return
System Circulator Cold Water Supply
Check Valve
Expansion Tank
Thermometer
Hot Water Supply
Storage Tank
Mixing Valve
Factory Supplied Manifold
Water Heater Circulator
Y-Strainer
Isolation Valve
T&P Relief Valve
Recirculation Filter
Thermal Solutions Products LLC
Notes:
1. This is a suggested piping configuration. It is the
installer's responsibility to to conform to local codes
and ordinances for additional requirements.
2. Relief valve shall not exceed the pressure
rating of any components in the system.
3. The circulator shall be sized to overcome the
pressure drop across the entire loop.
5/28/2019
AMP/BFIT Water Heater with 2 Tanks
Figure 25: Single Appliance, Two Tanks
XI . Hot Water Supply Boiler Piping
(continued)