Thermal Solutions AMP 1000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 55 / 88

55
Check Valve
Thermometer
Low Temp Water Supply
Mixing Valve
High Temperature Return
Check Valve
Isolation Vavle
Y-Strainer
Storage Tank
Expansion Tank
High Temp Water Supply
Factory Supplied
Manifold
Water Heater
Circulator
Low Temp
Return
Cold Water
Supply
T&P Relief
Valve
Recirculation Filter
Thermal Solutions Products LLC
Notes:
1. This is a suggested piping configuration. It is the
installer's responsibility to to conform to local codes
and ordinances for additional requirements.
2. Relief valve shall not exceed the pressure
rating of any components in the system.
3. The circulator shall be sized to overcome the
pressure drop across the entire loop.
5/28/2019
AMP/BFIT 1 Heater 1 Tank 2 Temperature Piping
NOTICE NOTICE
1. These are suggested piping configurations. It is the installer's responsibility to
conform to local codes and ordinances for additional requirements.
2. Pressure relief valve rating shall not exceed pressure rating of any component
in the system.
3. Some piping components cannot be supported by the pipping. Refer to the
manufactures' installation instructions.
4. Circulation pump must be sized to overcome the pressure drop across the entire
loop.
!
Figure 24: Two Temperatures, Single Appliance, Single Tank
XI . Hot Water Supply Boiler Piping
(continued)