THERMACUT EX-TRAFIRE 30H, Руководство оператора

Страница: 7 / 56

EX-TRAFIRE
®
30H
Operator Manual, Revision T-15 7
Touching electrical parts could cause a fatal shock or severe
burns�
•
Do not touch live electrical components�
• Wear dry insulated gloves, shoes and protective clothing�
• Insulate yourself from the work and ground using dry
insulating material large enough for the work area�
•
The working area should be clean and dry�
•
Switch OFF the system for cleaning and maintenance
operations�
• Do not wrap cables around your body�
•
Turn OFF the power supply when remain not used�
ELECTRIC SHOCK CAN KILL
• Periodically check the power supply cable, the
insulation must be intact� Replace the power supply
cable immediately if damaged� DO NOT use the
system with bare or exposed wires, this is highly
dangerous�
• Before removing the cover or handling any of the
internal components of the system, wait 5 (FIVE)
minutes to ensure complete discharge of the
capacitors�
• Keep the system in good condition; repair or replace
damaged parts immediately� Maintain the system in
accordance with the manual�
FIRE PREVENTION
• Keep flammable items away from the work area�
• Ensure that there is a fully charged fire extinguisher in the
work area
•
Ventilate the work area, check for flammable/combustible
gases, liquids and materials, remove prior to cutting as
they present a fire risk�
EXPLOSION PREVENTION
•
Do not cut in areas containing explosives, flammable
gases or vapors�
• Do not place the system on, over, or near combustible
surfaces�
• Do not operate the system in areas with an atmosphere
containing high concentrations of dust, flammable gases
or vapors�
• Do not use the system to cut pressurised containers that
have not been de-pressurised, vented and cleaned�
Caution! After cutting, the work piece will be HOT!
•
Do not touch hot parts bare handed, wear suitable
hand protection�
• Allow cooling time before handling�
CUTTING CAN CAUSE FIRE
OR EXPLOSION
Flying sparks are created during the metal cutting/gouging
processes; the area should be kept free from flammables�
•
Use face shield/safety glasses with side protection�
•
Wear flame resistant clothing, footwear and hand
protection�
• Use earplugs/defenders that are flame resistant to
prevent sparks entering the ear and to reduce the
noise level�
FLYING SPARKS (ARC SPRAY) CAN
CAUSE INJURY, FIRE OR EXPLOSION
The plasma arc is activated immediately after the torch trigger
is depressed�
•
Turn off the power before changing the torch
consumables, the plasma arc can burn through skin and
gloves�
• Do not place the hand or hold the work piece near the
cutting path�
•
Do not point the torch toward yourself or other persons�
PLASMA ARC CAN INJURE
3
4
5
HOT PARTS CAN CAUSE SEVERE BURNS