SANTA FE CLASSIC CONDENSATE PUMP INSTALLATION INSTRUCTIONS
STEP 1:
The condensate pump kit
includes: drain hose, condensate pump, two
mounting screws and instructions.
STEP 4:
Cut the condensate drain hose at a 45°
angle approximately 10 inches from the unit.
STEP 7:
Insert the drain hose into the
condensate pump reservoir as shown.
STEP 2:
Pre-drilled mounting holes are located
near the bottom and on the same side of the
unit as the drain hose.
STEP 5:
Example of hose cut at a 45° angle.
The angle prevents the hose from sealing tight
against the bottom of the pump reservoir.
STEP 8:
Install the provided drain hose over
the condensate pump nipple.
STEP 3:
Secure the condensate pump to the
unit with the two provided screws.
STEP 6:
Remove the plug as shown.
STEP 9:
Route the condensate pump drain hose
to an appropriate drain and plug the condensate
pump into a standard 115VAC outlet.
10
Santa Fe Classic Installer’s & Owner’s Manual
