Themis RES-22XR3, Руководство по установке

Страница: 87 / 162

3-17
Themis Computer
3—BIOS Setup Utility
Advanced Setup Configurations
32-Bit Data Transfer
Select Enable to allow the function of 32-bit IDE data transfer. The options are
Enabled (default) and Disabled.
3.3.5 PCI/PnP Configuration
3.3.5.1 Clear NVRAM
This feature clears the NVRAM (Non-Volatile Memory used for Flash ROM) during
system boot. The options are
No (default) and Yes.
3.3.5.2 Plug & Play OS
Selecting Yes allows the OS to configure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select
No
(default) to allow the AMI BIOS to configure all devices in the system.
3.3.5.3 PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32,
64 (default), 96,
128, 160, 192, 224 and 248.
3.3.5.4 PCI Cache Size
Use this feature to select PCI Cache size. The options are 16, 32, 64 (default), and
128.
3.3.5.5 PCI IDE BusMaster
When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE drives.
The options are Disabled and
Enabled (default).
3.3.5.6 SR-IOV Supported
Select Enabled to allow Single Root I/O Virtualization (SR-IOV) support which
works in conjunction with the Intel Virtualization Technology allowing multiple
operating systems to run simultaneously within a single computer via native sharing
of the PCI-Express devices in order to enhance network connectivity and perfor-
mance. The options are Enabled and
Disabled (default).